![]() You may need to modify rules in the LAN tab as well. ![]() Go to Firewall -> Rules -> WIFI and add pass ruless. It's important to add "pass" rules to the WiFI interface, otherwise all your connections and packets will be dropped. You may temporarily lose the connection and may need to refresh the browser window. LAN is on 192.168.1.0/24 and Wireless is on 192.168.2.0/24 - if you don't bridge these two networks, you won't be able to connect between LAN and wireless hosts. This step is not stricly necessary, but it's convenient to be able to connect to the LAN hosts when you are on WIFI. See out throughput test for the different modes in the Wireless throughput test article. If you don't have any old hardware that needs to use this access point, then we highly recommend using 802.11na mode because throughput and performance will be much better. If you must connect with old 802.11g devices, you have to choose the 802.11ng mode otherwise your old hardware won't see the new access point. Standard: 802.11ng or 802.11na - (see explanation below in "Which Standard and channel to use?")Ĭhannel: "11b/g/n - 11" or " a/n - 100 " - (see explanation below in "Which Standard and channel to use?")Įnable WME: checked (Force the card to use WME) - important(!!) IPv4 Address: 192.168.2.1/24 (WARNING: screenshot shows incorrectly /32 - don't make this mistake!) See the detailed screenshot for how we configure the interface by default. This is where the bulk of the configuration happens. Go to "Interface Assignment", select your newly created interface and click Add. This is somewhat confusing since you already "added" the card. If this field is empty, your card is either not supported by pfSense or improperly installed. In the "Parent interface" drop-down you should see your wireless card. Allow the Wifi interface traffic through the firewall.Make sure your card is properly mounted in the mPCIe slot and the pigtail cables are plugged in tightly.Have wireless card that is supported by pfSense (for example WLE200NX).There are many tutorials all over the internet for pfSense wireless configuration, but most of them don't seem to work work and the rest is for the previous pfSense versions.Īt TekLager we configure wireless for clients almost every day, and this is how we do it. ![]() This article has been last updated on April 12, 2019 PfSense 2.4 WIFI configuration: a helpful illustrated guide ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |